Abstract
Endpoint detection (EPD) is very important undertaking on the side of getting a good understanding and figuring out if a plasma etching process is done on the right way. It is truly a crucial part of supplying repeatable effects in every single wafer. When the film to be etched has been completely erased, the endpoint is reached. In order to ensure the desired device performance on the produced integrated circuit, many sensors are used to detect the endpoint, such as the optical, electrical, acoustical/vibrational, thermal, and frictional. But, except the optical sensor, the other ones show their weaknesses due to the environmental conditions which affect the exactness of reaching endpoint. Unfortunately, some exposed area to the film to be etched is very low (<0.5%), reflecting low signal and showing the incapacity of the traditional endpoint detection method to determine the wind-up of the etch process. This work has provided a means to improve the endpoint detection sensitivity by collecting a huge numbers of full spectral data containing 1201 spectra for each run, then a new unsophisticated algorithm is proposed to select the important endpoint traces named shift endpoint trace selection (SETS). Then, a sensitivity analysis of linear methods named principal component analysis (PCA) and factor analysis (FA), and the nonlinear method called wavelet analysis (WA) for both approximation and details will be studied to compare performances of the methods mentioned above. The signal to noise ratio (SNR) is not only computed based on the main etch (ME) period but also the over etch (OE) period. Moreover, a new unused statistic for EPD, coefficient of variation (CV), is proposed to reach the endpoint in plasma etches process.
Article PDF
Similar content being viewed by others
References
M. Mitchner and C. H. Kruger, Partially ionized gases. New York: Wiley, 1973.
ChemWiki: The dynamic chemistry hypertext. http://chemwiki.ucdavis.edu/Analytical_Chemistry/Q ualitative_Analysis/Classification_of_Matter.
W. Taylor, “Technical synopsis of plasma surface treatments,” Dissertation for the Degree of University of Florida, Gainesville, FL, December, 2009.
B. Goodlin, “Multivariate endpoint detection of plasma etching processes,” Ph.D. dissertation, Dept. Massachusetts Institute of Technology, U. S. A., 2002.
R. Yang and R. Chen, “Real-time plasma process condition sensing and abnormal process detection,” Sensors, 2010, 10(6): 5703–5723.
J. Yang, C. McArdle, and S. Daniels, “Dimension reduction of multivariable optical emission spectrometer datasets for industrial plasma processes,” Sensors, 2014, 14(1): 52–67.
J. Yang, “Multivariable OES data analysis for plasma semiconductor etching process,” Ph.D. dissertation, Dept. Dublin City University, Republic of Ireland, 2014.
D. Mercier, M. Bouttemy, J. Vigneron, P. Chapon, and A. Etcheberry, “GD-OES and XPS coupling: a new way for the chemical profiling of photovoltaic absorbers,” Applied Surface Science, 2015, 347 (2015): 799–807.
H. K. Chiu, “Method of controlling plasma etch process,” US patent 6703250 B2, 2004 March 9.
P. M. Cederstav. “Increase vacuum processing throughput and yield using advanced downstream pressure control methods,” in The 44th Annual Technical Conference Proceedings, Philadelphia, pp. 501–502, 2001.
Z. Fekete, “Development and characterisation of silicon microfluidic components and systems.” Ph.D. dissertation, Dept. Institute for Technical Physics and Materials Science Research Centre for Natural Sciences, Hungarian Academy of Sciences, Budapest, 2012.
C. J. Pugh, “End point detection in reactive ion etching,” Ph.D. dissertation, Dept. University College London, London, 2013.
B. M. Wise, N. B. Gallagher, S. W. Butler, D. D. White, and G. G. Barna, “A comparison of principal component analysis, multiway principal component anal ysis, trilinear decomposition and parallel factor analysis for fault detection in a semiconductor etch process,” Journal of Chemometrics, 1999, 13(13): 379–396.
B. M. Wise and N. B. Gallagher, PLS Toolbox Version 2.0, Manson, WA: Eigenvector Research, Inc., 1998.
I. T. Joliffe, Principal component analysis, New York: Springer-Verlag, 2002.
B. Kim and M. Kwon, “Optimization of PCA-applied in-situ spectroscopy data using neural network and genetic algorithm,” Applied Spectroscopy, 2008, 62(1): 73–77.
H. S. Kim, Y. J. Sung, D. W. Kim, T. Kim, M. D. Dawson, and G. Y. Yeom, “Etch end-point detection of GaN-based device using optical emission spectroscopy,” Materials Science and Engineering: B, 2001, 82(1–3): 159–162.
J. Chen and J. Liu, “Derivation of function space analysis based PCA control charts for batch process monitoring,” Chemical Engineering Science, 2001, 56(10): 328–3304.
S. Yoon and J. F. MacGregor, “Statistical and causal model-based approaches to fault detection and isolation,” Aiche Journal, 2000, 46(9): 1813–1824.
R. L. Gorsuch, Factor analysis (2nd ed.). Hillsdale, NJ: Lawrence Erlbaum Associates, 1983.
S. Krnac and P. P. Povinec, “Factor analysis of semiconductor γray spectra,” Applied Radiation and Isotope, 1996, 47(9–10): 905–910.
E. Brannock, M. Weeks, and R. Harrison, “The effect of wavelet families on watermarking,” Journal of Computers, 2009, 4(6): 554–566.
I. Daubechies, “Orthonormal bases of compactly supported wavelets,” Communications on Pure and Applied Mathematics, 1988, 41(7): 909–996.
D. L. Donoho, I. M. Johnstone, G. Kerkyacharian, and D. Picard, “Wavelet shrinkage: asymptopia–” Journal of the Royal Statistical Society-Series B, 1995, 57(2): 301–337.
D. L. Donoho and I. M. Johnstone, “Ideal spatial adaptation by wavelet shrinkage,” Biometrica, 1994, 81(3): 425–455.
D. L. Donoho and I. M. Johnstone, “Adapting to unknown smoothness via wavelet shrinkage,” Journal of the American Statistical Association, 1995, 90(432): 1200–1224.
D. L. Donoho and I. M. Johnstone, “Minimax estimation via wavelet shrinkage,” The Annals of Statistics, 1998, 26(3): 879–921.
R. A. Groeneveld, “Influence functions for the coefficient of variation, its inverse, and CV comparisons,” Communications in Statistics-Theory and Methods, 2011, 40(23): 4139–4150.
Author information
Authors and Affiliations
Corresponding author
Additional information
This article is published with open access at Springerlink.com
Rights and permissions
Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (https://creativecommons.org/licenses/by/4.0), which permits use, duplication, adaptation, distribution, and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.
About this article
Cite this article
Ben Zakour, S., Taleb, H. Shift endpoint trace selection algorithm and wavelet analysis to detect the endpoint using optical emission spectroscopy. Photonic Sens 6, 158–168 (2016). https://doi.org/10.1007/s13320-016-0280-5
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13320-016-0280-5