Abstract
The paper focuses on the erosion resistance test based on surface treatment by a high-speed water jet applied on concrete. A reference concrete sample and concrete samples with three types of solution of modified lithium silicates applied on the concrete surface were tested under various erosion conditions. Two different jet impact angles (45° and 90°) were investigated. A significant difference in the erosion rate in the surface layers was observed comparing the untreated concrete and the concrete treated by various solutions of modified lithium silicates, but only in the initial phase of erosion.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Binici, H., Aksogan, O., Gorur, E.B., Kaplan, H., Bodur, M.N.: Hydro-abrasive erosion of concrete incorporating ground blast-furnace slag and ground basaltic pumice. Constr. Build. Mater. 23, 804–811 (2009)
Galvao, J.C.A.: Abrasive effects observed in concrete hydraulic surfaces of dams and application of repair materials
Hela, R., Bodnárová, L., Sitek, L., Foldyna, J.: High-speed water jet technology for renovation of concrete structures - new trends and possibilities. Cement-Wapno-Beton, vol. 15, 268 p. (2010)
Hlaváč, L.M., Bodnárová, L., Janurová, E., Sitek, L.: Comparison of continuous and pulsing water jets for repair actions on road and bridge concrete. Baltic J. Road Bridge Eng. 7, 53–59 (2012). https://doi.org/10.3846/bjrbe.2012.08
Horszczaruk, E.K.: Hydro-abrasive erosion of high performance fiber-reinforced concrete. Wear 267, 110–115 (2009)
Hu, X.G., Momber, A.W., Yin, Y.G.: Hydro-abrasive erosion of steel-fibre reinforced hydraulic concrete. Wear 253, 848–854 (2002)
Hu, X.G., Momber, A.W., Yin, Y.: Erosive wear of hydraulic concrete with low steel fiber content. J. Hydraul. Eng. 132, 1331–1340 (2006)
Momber, A.W.: Short-time cavitation erosion of concrete. Wear 241, 47–52 (2000)
Momber, A.W.: Effects of erodent flow energy and local exposure time on the erosion of cement-based composites at high-speed hydro-abrasive flow. Wear 378–379, 145–154 (2017)
Saegrov, S., Hafskjold, L.S., Konig, A., et al.: Wastewater network challenges and solutions. In: Hlavinek, P., Kukharchyk, T., Marsalek, J., Mahrikova, I. (eds.) Conference NATO Advanced Research Workshop on Integrated Urban Water Resources Management, Senec, Slovakia, 19–23 Oct 2005, NATO Science for Peace and Security Series C-Environmental Security, pp. 147–158. Springer, Dordrecht (2006)
Sitek, L., Bodnárová, L., Válek, J., et al.: Effects of water jet on heat-affected concretes. In: Juozapaitis, A., Vainiunas, P., Zavadskas, E.K. (eds.) Modern Building Materials, Structures and Techniques, Procedia Engineering, vol. 57, pp. 1036–1044 (2013). https://doi.org/10.1016/j.proeng.2013.04.131
Acknowledgement
This work was supported by grant of the Czech Science Foundation (18-25035S) and by project of the Institute of Clean Technologies for Mining and the Utilization of Raw Materials for Energy Use – Sustainability program, reg. no. LO1406 financed by the Ministry of Education, Youth and Sports of the Czech Republic. Some parts of presented work was also supported by a project for the long-term conceptual development of research organisations RVO: 68145535. The authors are very thankful for the support.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2019 Springer Nature Switzerland AG
About this paper
Cite this paper
Hlaváček, P., Sitek, L., Hela, R., Bodnárová, L. (2019). Erosion Test with High-speed Water Jet Applied on Surface of Concrete Treated with Solution of Modified Lithium Silicates. In: Hloch, S., Klichová, D., Krolczyk, G., Chattopadhyaya, S., Ruppenthalová, L. (eds) Advances in Manufacturing Engineering and Materials. Lecture Notes in Mechanical Engineering. Springer, Cham. https://doi.org/10.1007/978-3-319-99353-9_15
Download citation
DOI: https://doi.org/10.1007/978-3-319-99353-9_15
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-99352-2
Online ISBN: 978-3-319-99353-9
eBook Packages: EngineeringEngineering (R0)